best 10 bandsaw
A board with one square edge and side is necessary. Problem is most woodworkers dont have a clue how to do this. Successful resawing calls for nothing more complicated than appropriate blade selection adequate tension setting the fence and proper stock control. Blade Selection: As you saw through very thick stock you put a lot of pressure on every part of the blade engaged in the cut. Each saw tooth shaves out waste. Blades with 3 teeth per inch (tpi) have large gullets which have room for a lot of waste. Thrust bearings support the blade above and below. During the actual cut only the blades stiffness or "beam strength" will keep the cut proceeding straight and free of wander. Its my experience that a quality 1/2" 3-tooth blade gives good results. I tried wider blades with no increase in efficiency.
With a number of bandsaw models now available in the market it is quite difficult to find the right bandsaw to meet your requirements you often find bandsaws that look alike but vary greatly in price. Some bandsaws may be made in the same factory but have different features. Base models may be the same but some of the upgrades may be different. Getting to the depth of the matter Woodworkers must remember that while choosing a bandsaw it is important not to look only at outward appearances but compare the details. Ask the dealer questions and make an informed decision based on the quality features and reliability of the machine. Also make sure you attach a value to every feature you want to consider and the tasks that you need to perform whether immediate or in the long run.
Most Popular This Week
I realized that a good quality blade of half inch 3-teeth offers good results though I did try wider blades without any increased efficiency. Tension: sufficient blade tension ensures that your blade doesnt move erratically under pressure. As a typical tension gauge doesnt give really accurate results its better to have slightly additional tension than it indicates. You can verify that by opening the lateral guides and thrust bearings. Back off the two below and above the table thus disabling them to remain in contact with the blade. Next crank the tension gauge for getting the needed setting. Push the blade sideways by nearly midway between the lower and upper wheels. Now the blade would easily turn aside for a little length. The movement to sideways should be quarter inch.
On being pushed harder this will bend more but quarter inch is a distinctive point at which it wont deflect easily. In case you are able to deflect it more than a quarter inch add more tension till the deflection equals quarter of an inch. Stock Control: Any superior bandsaw blade is designed to cut across straight lines. Yet each blade does that in its characteristic way. Thats because each blade acquires its exclusive "lead angle". So how can one find out this exclusive lead angle? Many suggest referring to some Resaw Guide. Its like one point that enables you to alter your feed angle your to the blade. One takes time getting used to this method. Additionally it demands steady attention. Having once determined the right direction for feed adjust the fence of bandsaw accordingly and keep cutting straight lines.